Lpc47B387 I/O Controller Functions - HP Compaq d330 DT Technical Reference Manual

Hp compaq d330 dt: reference guide
Hide thumbs Also See for Compaq d330 DT:
Table of Contents

Advertisement

Chapter 4 System Support

4.8.2 LPC47B387 I/O CONTROLLER FUNCTIONS

The LPC47B387 I/O controller contains various functions such as the keyboard/mouse interfaces,
diskette interface, serial interfaces, and parallel interface. While the control of these interfaces
uses standard AT-type I/O addressing (as described in chapter 5) the configuration of these
functions uses indexed ports unique to the LPC47B387. In these systems, hardware strapping
selects I/O addresses 02Eh and 02Fh at reset as the Index/Data ports for accessing the logical
devices within the LPC47B387. Table 4-16 lists the PnP standard control registers for the
LPC47B387.
Table 4-16 LPC47B387 I/O Controller Registers
LPC47B387 I/O Controller Control Registers
Index
Function
02h
Configuration Control
03h
Reserved
07h
Logical Device (Interface) Select:
00h = Diskette Drive I/F
01h = Reserved
02h = Reserved
03h = Parallel I/F
04h = Serial I/F (UART 1/Port A)
05h = Serial I/F (UART 2/Port B)
06h = Reserved
07h = Keyboard I/F
08h = Reserved
09h = Reserved
0Ah = Runtime Registers (GPIO Config.)
0Bh = SMBus Configuration
20h
Super I/O ID Register (SID)
21h
Revision
22h
Logical Device Power Control
23h
Logical Device Power Management
24h
PLL / Oscillator Control
25h
Reserved
26h
Configuration Address (Low Byte)
27h
Configuration Address (High Byte)
28-2Fh
Reserved
NOTE:
For a detailed description of registers refer to appropriate SMC documentation.
The configuration registers are accessed through I/O registers 2Eh (index) and 2Fh (data) after the
configuration phase has been activated by writing 55h to I/O port 2Eh. The desired interface
(logical device) is initiated by firmware selecting logical device number of the 47B347 using the
following sequence:
1. Write 07h to I/O register 2Eh.
2. Write value of logical device to
3. Write 30h to I/O register 2Eh.
4
. Write 01h to I/O register 2Fh (this activates the interface).
Writing AAh to 2Eh deactivates the configuration phase.
4-30
hp compaq d330 and d530 Series of Personal Computers
Featuring the Intel Pentium 4 Processor
Table 4-16.
I/O register 2Fh.
First Edition – June 2003
Reset Value
00h
00h
56h
--
00h
00h
04h

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents