HP Compaq d330 DT Technical Reference Manual page 32

Chapter 2 System Overview
2.3.2.2 Slim Tower Chassis
The Slim Tower (ST) chassis used for the d330 models provides reasonable expansion and
upgrade capability in a small footprint with the following features:
♦ Tilting card cage for access to DIMM and processor sockets
♦ One low-profile AGP 8X slot
♦ Three half-height (low-profile) PCI slots (see note below)
♦ May be used horizontally as a desktop or mounted vertically in tower stand (supplied)
NOTE: The d330 slim tower chassis may be ordered in the chassis configuration that
uses a riser card to provide two full-height PCI slots. This configuration will very
similar to the layout shown in Figure 2-6 for the small form factor.
System Board
Back
Low Profile AGP Slot
Low Profile PCI Slot 1
Low Profile PCI Slot 2
Low Profile PCI Slot 3
Power Supply
Figure 2-5. Slim Tower Chassis Layout, Tower Configuration, Left View
2-8 hp compaq d330 and d530 Series Personal Computers
Featuring the Intel Pentium 4 Processor
First Edition– June 2003
Multibay Drive
Front
Diskette Drive
Speaker