Installing Pci Boards - HP OmniBook 900 User Manual

Installing PCI Boards

The dock has two PCI half-length slots for adding PCI half-length accessory boards to
your dock. You may install any supported PCI half-length board in either of the two
PCI slots in the dock. ISA and E-ISA boards are not supported by the dock.
To install a PCI accessory board
Refer to the installation instructions that came with your PCI accessory board for
any board-specific instructions for configuring the board.
If you have difficulty accessing the PCI board slots through the PCI access door, you
can remove the top cover of the dock for easier access (optional). See "Using the
alternate installation procedure" on page 1-49.
1. Turn of the OmniBook.
2. Disconnect the power cord from the dock.
3. Remove the PCI access door on the right side of the dock.
Installing Accessories
1-47