Gigabyte GA-8N-SLI Quad Royal User Manual page 87

After that, the Array List screen displaying the RAID array you created will appear (Figure 10).
If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array
and press B. The Boot section will show Yes.
Boot
No
[Ctrl-X] Exit
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
11), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
RAID Mode: Mirroring
Striping Width : 1
Adapt Channel
2 0
2 1
[R] Rebuild
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
MediaShield RAID Utility Feb 8 2005
- Array List -
Id Status Vendor
2 Healthy NVIDIA
[ ] Select [B] Set Boot
Figure 10
Array 2 : NVIDIA MIRROR 111.79G
- Array Detail -
Striping Block: 64K
M/S Index Disk Model Name
Master 0 ST3120026AS
Master 1 ST3120026AS
[D] Delete [C] Clear Disk
Figure 11
- 87 -
Array Model Name
MIRROR 111.79G
[N] New Array [ENTER] Detail
Capacity
111.79GB
111.79GB
[ENTER] Return
Appendix