Gigabyte GA-8N-SLI Quad Royal User Manual page 18

Enabling SLI Mode--
Set the SLI switch module:
Note that as the switch module (GC-SLISW-C19) is preinstalled in the Normal Mode direction by factory default,
the first step to enable SLI mode on your system is to take out the module from the socket, turn it around and
insert it in the SLI Mode direction.
Step 1: Gently spread the retaining clips of the socket and the
module may then be removed from the socket. Hold the
module by the edges and lift it away from the socket.
Step 2: Position the SLI Mode side of the module above the socket at
a 25 angle. Align the small notch at the top edge of the module
o
with the key in the socket.
Step 3: Insert the top edge of the module into the socket. Make sure
the gold edge connectors are fully inserted.
Step 4: Gently press down on the two ends of the module until it is
locked in place by the socket clips. (You should hear a "click"
when the module is attached.)
GA-8N-SLI QUAD Royal Motherboard - 18 -