These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following product: SKR3 SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations.
Do not overload this accessory or subject it to conditions outside its rating This product is Class I and must be earthed This product is IP20 rated INSTALLATION INSTALLATION Note: The unit should be fixed to a rigid flat surface as unevenness could cause damage to he unit should be fixed to a rigid flat surface as unevenness could cause damage to the product or the product or affect operation peration...
Feed the cable and product through the hole Tighten screws on top of product to secure it to the surface (see Fig. 2) • Feed the cable and product through the hole • Tighten screws on top of product to secure it to the surface (see Fig. 2) Fig.
WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. WARNING This unit should NOT be subject to any insulation resistance testing, failure to follow this instruction could cause damage to the USB circuit and void the warranty Please note that we do not recommend our 13A sockets be used for Electric Vehicle (EV)
Page 6
SUPPLIED BY: (UK) MANUFACTURER ML ACCESSORIES LTD, UNIT E CHILTERN PARK, BOSCOMBE ROAD, DUNSTABLE LU5 4LT, WWW.MLACCESSORIES.CO.UK (EU) AUTHORISED REPRESENTATIVE SLV LIGHTING GROUP, DAIMLERSTRASSE 21-23, 52531 ÜBACH-PALENBERG, GERMANY EMAIL: EPREL@GROUP.SLV.COM MADE IN CHINA AKAPR22_V4...
Need help?
Do you have a question about the SKR3 and is the answer not in the manual?
Questions and answers