Memory; Additional Memory - Gateway Solo 2100 User Manual

Memory

The system ships with at least 8MB of RAM on board. The RAM capacity can
be upgraded to 40MB by installing optional memory modules in the two
expandable memory sockets, located on the underside of the system. These
sockets accept 8MB or 16MB modules.
Figure 30. Memory Module
To install a memory module:
1 . Save all work.
2 . Press the power button, or press and hold the power button for two
3 . Close the lid.
4 . Follow electrostatic discharge precautions when adding memory.
5 . Disconnect the AC power.
seconds if you configured the power button for Suspend/Resume mode
to turn the system completely off.
Preventing Electrostatic Discharge (ESD) Damage
The components inside your system are extremely sensitive to electrostatic discharge,
better known as static electricity. Static electricity can cause irreparable damage to your
system; however, if you follow the Sequential Procedure for grounding yourself and take
note of the Handling Precautions, you should easily be able to avoid the possibility of such
damage occurri n g.
Sequential Procedure
1. Wear a grounding wrist strap if one is available (available at most electronic stores).
2. Turn off the system power.
3. Remove the battery pack.
4. Remove all the cables.
Handling Precautions
o Never slide memory modules or other parts over any surface. Avoid static-causing
surfaces such as plastic and styrofoam in your work area.
o Remove the part from its antistatic bag only when you are ready to use it. Do not
lay the part on the outside of the antistatic bag, as only the inside of the bag pro-
vides antistatic protection.
o Always hold cards by their edges and their metal mounting bracket. Avoid touching
components on the cards and the edge connectors that connect to expansion slots.
User's Guide 35