Gateway Solo 2100 User Manual page 53

Diskette A:
Selects the drive type.
IDE Adapter 0 master:
Note:
This sub-menu configures the IDE adapter (see Figure 45). Press Enter to
access the sub-menu for this function. Press Esc when you have finished
using the sub-menu, or wish to return to the Main menu.
IDE Adapter 1 master:
This sub-menu is only used with more than one hard drive. It functions the
same as IDE Adapter 0 master.
IDE Adapter 1 slave:
This sub-menu is only used with more than one hard drive. It functions the
same as IDE Adapter 0 master.
Display device selection:
Sets the video display device. Use the Spacebar to choose between LCD,
CRT or both LCD & CRT.
Built-in pointing device:
Enables or disables the EZ Pad pointing device. Press the Spacebar to select
Enabl e d or Di s abl e d.
Memory cache:
Enables or disables external memory cache. Press the Spacebar to select
Enabl e d or Di s abl e d.
Boot sequence:
Sets the order in which the system searches for the boot drive. Press the
Spacebar to choose between A: then C:, C: then A:, C: only, or CD-ROM.
The system memory and extended memory fields display the actual memory
à
See page 36.
available. You cannot access and change these fields. These fields will only
change if additional memory or a larger hard drive is installed.
Press the Esc key to access the Exit menu and accept/discard changes. Press
F9 to return to the factory defaults, or F10 to return to the previous settings.
Use the Right Arrow key to move over to the next screen.
Do not change these settings unless you are an advanced user!
Autotype fixed disk: — Auto-detects the drive and sets all drive values
to comply with ANSI specifications.
Type: — Change from Auto to User to edit Cylinders, Heads, Sectors/
T r a c k , e t c .
32 bit I/O: — Enables or disables 32-bit data transfers.
User's Guide 53