Chapter 2 Safety Precautions; Safety Symbols; Precautions For Operation - INVT XD7KTL User Manual

Single-phase Hybrid Solar Inverter

Chapter 2 Safety Precautions

Improper use may result in risk of electric shock or burns. This Manual provides important instructions for installation and
maintenance of the product. Please read this Manual carefully before using the product, and keep it for future reference.

2.1 Safety Symbols

The following are the safety symbols used in this Manual to indicate potential safety risks and important safety instructions.
WARNING!
The warning symbol indicates important safety information that, if not followed properly, could result
in serious personal injury or even death.
RISK OF ELECTRIC SHOCK!
The electric shock hazard symbol indicates important safety information that, if not followed, could
result in electric shock.
SAFETY TIPS!
This symbol indicates important safety information that, if not followed, could result in serious
personal injury or even death.
HIGH TEMPERATURE!
This symbol indicates safety information that, if not strictly followed, could result in burns.
WARNING!
When performing maintenance on the input and output of the inverter after disconnecting it, wait at
least 5 minutes for the inverter to discharge any remaining electrical charge.

2.2 Precautions for Operation

The XD7-10KTL series hybrid inverter has been designed and tested according to the applicable safety regulations. This ensures
the personal safety of the user. However, as an electrical equipment, the inverter could cause electric shock or other injuries if not
operated properly. Please operate the inverter in accordance with the following requirements:
1. The wiring, installation and commissioning work should be carried out by professionals.
2. Be sure to read this Manual before operating the product. We shall not be held liable for any failure or loss caused by improper
operation.
3. Before starting the installation or maintenance work, please break the connections at the AC side, DC side and battery side, and
then wait at least 5 minutes before proceeding to avoid electric shock.
4. When the inverter is running, the temperature of the housing is high. Do not touch it to avoid getting burned.
5. All electrical installations must conform to local electrical standards. The inverter should be connected to the power grid by
professionals with the permission of the local power provider.
6. During the installation, insulated tools and personal protective equipment should be used to ensure personal safety. To touch
the electronic components of the inverter, please wear anti-static gloves, anti-static wrist strap or anti-static clothing so as to protect
the inverter against electrostatic discharge.
7. Please install the inverter at a position that is out of the reach of children.
8. Do not plug or remove the AC/DC terminal during normal operation of the inverter.
9. The actual DC input voltage should not exceed the maximum allowable DC input voltage of the inverter.
10. Select an appropriate battery that matches the system, and set the battery type correctly. If you select a battery that does not
match the hybrid inverter, the system cannot run.
2
Product Introduction