Light
signalling
A4
G2
(when the battery is removed
from the vacuum cleaner)
• Let the vacuum cleaner recharge as soon as its suction performance is weaker.
• When using the vacuum cleaner for an extended period of time or in a hot environment, the
accumulator might be too hot for charging. Let the accumulator cool down prior to charging.
• Remove the adaptor each time after the battery is fully charged.
OPERATING TIMES
Set power
ECO
TURBO
* Note: The stated operating times are based on ETA's internal testing
and only apply to a new and fully charged battery. Depending on the
age and wear of the battery, the operating time decreases.
MOUNTING THE PLASTIC BRACKET TO THE WALL
Using suitable fasteners, attach the plastic bracket I to the wall.
• Make sure that the el. socket is close to the mounted plastic bracket.
• Make sure that no electricity, telephone or water lines etc. are routed under the
plaster near the area where the plastic bracket is mounted to the wall.
IV. USE OF VACUUM CLEANER (Fig. 6)
Let the vacuum cleaner charge sufficiently prior to using.
CONTROL
ON/OFF button (A1)
Suction power control (A2)
when pressed once
when pressed twice
Always switch the vacuum cleaner on at low suction power.
Status
Steady light
(all segments)
Lights off
Warning
Caution
- vacuum cleaner ON/OFF switch
- high suction power (TURBO)
- low suction power (ECO)
Caution
EN - 25
Meaning
The battery is charged.
Running Time *
Approx. 30 min.
Approx. 12 min.
EN
Need help?
Do you have a question about the NEXO and is the answer not in the manual?