Fujitsu FI-4860C Operator's Manual page 239

3) At <Screen8-1>, press
select consumable error process.
(1) [Stop] is blinking:
(2) [Message] is blinking: When the consumables replacement limit is
By pressing (Enter button), <Screen8-2> appears on the LCD.
4) At <Screen8-2>, specify the number of scans to get Consumables replacement
message.
Each time (Left arrow button) is pressed, the counter value decrements by
10,000.
Each time (Right arrow button) is pressed, the counter value increments by
10,000.
5) Press (Enter button) to confirm the setting.
Press (Exit button) , and the LCD display goes back to [Ready] screen.
(Left arrow button) or
When the consumables replacement limit is
reached, the Consumables replacement mes-
sage (Abrasion alarm) is shown on the LCD and
scanning stops.
reached, the Consumables replacement mes-
sage (Abrasion alarm) is shown on the LCD but
the scanning continues.
<Screen8-2>
0 8 - 2
!
= 3 0 0
(Right arrow button) to
A l m C
a r
0 0 0 s h e
7.3 Setup Mode Details
7
N T
e t
7-33