Mode Led View Button And Indicator Leds - HP J4902A Installation And Getting Started Manual

Mode LED View Button and Indicator LEDs

To optimize the amount of information that can be displayed for each of the
switch ports without overwhelming you with LEDs, the Switch 6108 uses a
Mode LED for each port. The operation of this LED is controlled by the Mode
LED View button, and the current setting is indicated by the Mode LED View
indicator LEDs near the button. Press the button to step from one mode to the
next.
Mode LED View button
and indicator LEDs
Spd mode:
off = 10 Mbps
Link
flash = 100 Mbps
on = 1000 Mbps
1
Act FDx Spd
Mode
Mode LED View
■ If the Activity (Act) indicator LED is lit, each Mode LED displays activity
information for the associated port—it flickers as network traffic is
received and transmitted through the port.
■ If the Full Duplex (FDx) indicator LED is lit, the Mode LEDs light for those
ports that are operating in full duplex.
If the Speed (Spd) indicator LED is lit, the Mode LEDs behave as follows
■
to indicate the connection speed for the port:
• Off = 10 Mbps
• Flashing = 100 Mbps (the flashing behavior is an on/off cycle once
every 0.5 seconds, approximately)
• On = 1000 Mbps
Introducing the HP Procurve Switch 6108
Mode LED
(one per port)
1 2
2
Front of the Switch
1-5