Optional) Connect A Console To The Switch 6108; Terminal Configuration - HP J4902A Installation And Getting Started Manual

Installing the Switch 6108
Installation Procedures

7. (Optional) Connect a Console to the Switch 6108

The Switch 6108 has a full-featured, easy to use console interface for
performing switch management tasks including the following:
■
■
■
■
■
The console can be accessed through these methods:
■
■
The Switch 6108 can simultaneously support one out-of-band console session
through the Console Port and one in-band Telnet console session.

Terminal Configuration

To connect a console to the switch, configure the PC terminal emulator as a
DEC VT-100 (ANSI) terminal or use a VT-100 terminal, and configure either
one to operate with these settings:
If you want to operate the console using a different configuration, make sure
you change the settings on both the terminal and on the switch so they are
compatible. Change the switch settings first, then change the terminal
settings, then reboot the switch and reestablish the console session.
2-16
Monitor switch and port status and observe network activity statistics
Modify the switch's configuration to optimize switch performance,
enhance network traffic control, and improve network security
Read the event log and access diagnostic tools to help in troubleshooting
Download new software to the switch
Add passwords to control access to the switch from the console, web
browser interface, and network management stations
Out-of-band: The Switch 6108 come with a serial cable for connecting a
PC or VT-100 terminal, to be used as a console, directly to the switch.
In-Band: Access the console using Telnet from a PC or UNIX station on
the network, and a VT-100 terminal emulator. This method requires that
you first configure the switch with an IP address and subnet mask by using
either out-of-band console access or through DHCP/Bootp. For more
information on IP addressing and on starting a Telnet session, see
chapter 3, "Getting Started With Switch Configuration", and the Manage-
ment and Configuration Guide, which is on the Documentation CD-ROM
that came with your switch.
• any baud rate from 1200 to 115200 (the switch senses the speed)
• 8 data bits, 1 stop bit, no parity, and flow control set to Xon/Xoff
• For the Windows Terminal program, also disable (uncheck) the "Use
Function, Arrow, and Ctrl Keys for Windows" option
• For the Hilgraeve HyperTerminal program, select the "Terminal keys"
option for the "Function, arrow, and ctrl keys act as" parameter.