Using The Rj-45 Connectors - HP J4897A Installation Manual

Using the RJ-45 Connectors

To connect:
Push the RJ-45 plug into the RJ-45
jack until the tab on the plug clicks
into place. When power is on for the
switch and for the connected device,
the Link LED for the port should light
to confirm a powered-on device (for
example, an end node) is at the other
end of the cable.
If the Link LED does not go on when
the network cable is connected to the
port, see "Diagnosing with the LEDs"
in chapter 3, "Troubleshooting".
To disconnect:
Press the small tab on the plug and
pull the plug out of the jack .
Installing the Series 2700 Switches
Installation Procedures
RJ-45 connector
100-ohm unshielded or shielded
twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 or better for 100 Mbps
ports
• Category 5E or better for 1000 Mbps
ports
Maximum distance: 100 meters
2-13