equipment. All troubleshooting and repair procedures are detailed to allow only
subassembly/module-level repair. Because of the complexity of the individual boards and
subassemblies, no one should attempt to make repairs at the component level or to make
modifications to any printed wiring board. Improper repairs can create a safety hazard.
clearance at the front and back of the server.
operation, plug the AC power cord into a properly grounded AC outlet only.
void any warranty.
Where to go for additional help
Go to the HP website (http://www.hp.com).
Click Support & Drivers.
Only authorized technicians trained by HP should attempt to repair this
To reduce the risk of electric shock, personal injury, and damage to the
Do not attempt to service any parts of the equipment other than those specified in the
following procedure. Any other activities may require that you shut down the server and
remove the power cord.
Installation and maintenance of this product must be performed by individuals who are
knowledgeable about the procedures, precautions and hazards associated with the
To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
Unplug the power cord from the power supply to disconnect power to the equipment.
Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord
extends from the server.
To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of
The server is designed to be electrically grounded (earthed). To ensure proper
Any indications of component replacement or printed wiring board modifications may
Technician notes 4