Table of Contents
Advertisement
Technician notes
Warnings, cautions, and notes
WARNING:
All troubleshooting and repair procedures are detailed to allow only subassembly/module-level
repair. Because of the complexity of the individual boards and subassemblies, no one should
attempt to make repairs at the component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
WARNING:
•
•
WARNING:
•
•
•
•
CAUTION:
clearance at the front and back of the server.
CAUTION:
operation, plug the AC power cord into a properly grounded AC outlet only.
NOTE:
void any warranty.
Downloading files
Go to the HP website (http://www.hp.com/#Support).
1.
Only authorized technicians trained by HP should attempt to repair this equipment.
To reduce the risk of electric shock, personal injury, and damage to the equipment:
Do not attempt to service any parts of the equipment other than those specified in the following
procedure. Any other activities may require that you shut down the server and remove the
power cord.
Installation and maintenance of this product must be performed by individuals who are
knowledgeable about the procedures, precautions and hazards associated with the product.
To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
Unplug the power cord from the power supply to disconnect power to the equipment.
Do not route the power cord where it can be walked on or pinched by items placed against it.
Pay particular attention to the plug, electrical outlet, and the point where the cord extends from
the server.
This symbol indicates the presence of a hot surface or hot component. If this surface is
contacted, the potential for injury exists.
WARNING:
To reduce the risk of injury from a hot component, allow the surface to cool
before touching.
To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of
The server is designed to be electrically grounded (earthed). To ensure proper
Any indications of component replacement or printed wiring board modifications may
Technician notes 4
Advertisement
Table of Contents
