Attaching The Brackets To The Switch - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Chapter 2 Installation
Note

Attaching the Brackets to the Switch

Note
78-6461-04
To mount a Catalyst 2912 LRE XL or 2924 LRE XL switch on a
wall, you need to obtain two special wall-mount brackets (Cisco part
number wallmount-1ru=.) To order these brackets, contact your
Cisco sales representative.
The bracket orientation and the screws you use depend on whether you are
attaching the brackets for parallel or vertical wall-mounting. Use two of the
supplied screws to attach each bracket, according to these guidelines:
For parallel wall-mounting, use the supplied Phillips truss-head screws to
•
attach the short side of the bracket to the switch.
For vertical wall-mounting, use the supplied Phillips flat-head screws to
•
attach the long side of the bracket to the switch.
The Catalyst 2912 LRE XL and 2924 LRE XL switches cannot be mounted
vertically on a wall.
Figure 2-13 and Figure 2-13
switch. Follow the same steps to attach the second bracket to the opposite side of
the switch.
Figure 2-13 Attaching Brackets for Parallel and Vertical Wall-Mounting for
Fixed-Port Switches
show how to attach the brackets to one side of the
Catalyst 2900 Series XL Hardware Installation Guide
Installing the Switch on a Wall
Phillips
truss-head
screws
2-21