Port Leds And Modes - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Front-Panel Description
Table 1-3 RPS LED on the Catalyst 2912 LRE XL and 2924 LRE XL Switches (continued)
Color RPS Status
Solid amber The RPS is in standby mode or in a fault condition. Press the Standby/Active button
on the RPS, and the LED should turn green. If it does not, the RPS fan could have
failed. Contact Cisco Systems.
Blinking amber The internal power supply in a switch has failed, and the RPS is providing power
to the switch (redundancy has been allocated to this device).

Port LEDs and Modes

Table 1-4 Port Mode LEDs on the Catalyst 2912 XL, 2924C XL, 2924 XL, 2924MF XL, 2924M XL, and
2924M XL DC Switches
Mode LED Port Mode
STAT Port status
UTL Switch utilization
FDUP Port duplex mode
100 Port speed
Catalyst 2900 Series XL Hardware Installation Guide
1-14
Each of the 10/100, 100BASE-FX, and LRE ports and module slots have a port
LED. These port LEDs, as a group or individually, display information about the
switch and about the individual ports. The port modes
determine the type of information displayed.
To select or change a mode, press the Mode button until the desired mode is
highlighted. When you change port modes, the meaning of the port LED colors
also changes. Table 1-6
Description
The port status. This is the default mode.
The current bandwidth in use by the switch. (See
The port duplex mode: full duplex or half duplex, and default
modes:
10/100 ports: auto
•
100BaseFX ports: auto
•
Gigabit ports: auto
•
The port operating speed: 10 or 100 Mbps.
and Table 1-7 list the port LED colors.
Chapter 1 Product Overview
(Table 1-4 and Table 1-5)
Figure 1-8.)
78-6461-04