Leds - Cisco Catalyst WS-C2924-XL Hardware Installation Manual

Chapter 1 Product Overview
Note

LEDs

78-6461-04
Table 1-1 Expansion Modules (continued)
Module Type
1000BASE-T
1
Ethernet Gigabit
ATM
1. The Ethernet Gigabit module supports several
Gigabit Interface Converter (GBIC) devices. For a
complete list and the minimum software release
required, refer to the Release Notes for the Catalyst
2900 Series XL and Catalyst 3500 Series XL
Switches.
These modules automatically configure themselves when you insert them in
module slots and tighten the thumb screws. A power-on self-test (POST) verifies
that the module is working properly before it starts forwarding packets.
Modules WS-X2914-XL and WS-X2922-XL support 2048 MAC addresses. If
you install one of these modules in a 2924M XL or Catalyst 2912MF XL switch
(both supporting 8192 MAC addresses), the module fails POST. You can start the
module by restarting that switch. After the restart, the switch address capacity is
reduced to 2048 MAC addresses.
Refer to the Catalyst 2900 Series XL Modules Installation Guide and the
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide for
detailed information on expansion modules for Catalyst 2900 series XL switches.
You can use the switch LEDs to monitor switch activity and its performance.
Figure 1-5, Figure 1-6, and
Mode button that you use to select a port mode. Changing a port mode changes
the information provided by each port LED.
Model Number
WS-X2932-XL
WS-X2931-XL
WS-X2971-XL
WS-X2972-XL
WS-X2951-XL
WS-X2961-XL
Figure 1-7 show the location of the LEDs and the
Catalyst 2900 Series XL Hardware Installation Guide
Front-Panel Description
1-9