Cisco CISCO2515-RF - 2515 Router User Manual page 46

Connecting to a Network
Take the following steps to connect your router to a network:
Step 1
Note
from the AUI connector and attach the jackscrews provided.
Figure 3-11
Ethernet
AUI cable
(not supplied)
BNC connector
To thin
Ethernet
network
3-14 Router Installation and Configuration Guide
Connect the Ethernet AUI port (DB-15) to an Ethernet transceiver, as shown in
Figure 3-11. Or connect a transceiver directly to the Ethernet AUI port.
If your Ethernet connection requires jackscrews, remove the slide-latch assembly
Connecting an Ethernet Transceiver
TOK EN RING
Ethernet AUI port
(DB-15)
(with jackscrews
Ethernet
transceiver or slide-latch)
To thin
Ethernet
network
Router