Connecting The System Cables - Cisco ASR1006-10G-SEC/K9 - ASR 1006 VPN+FW Bundle Router Installation Manual

Chapter 6 Cisco ASR 1006 Router Overview and Installation
Run the cable up and through the cable-management bracket and connect the other end of the RJ-45
Step 2
cable to the RJ-45 adapter (see
Figure 6-26
1
2
Connect the adapter to your video terminal to complete the cable connection.
Step 3
Step 4 Power on your video terminal.
Step 5 Configure your video terminal to match the following default console port settings: 9600 baud, 8 data
bits, No parity generation or checking, 1 stop bit, and No flow control.
Step 6 Go to the

Connecting the System Cables

Keep the following guidelines in mind when connecting external cables to the Cisco ASR 1006 Router:
•
•
OL-13208-09
Cable-Management Bracket with Cabling in the Cisco ASR 1006 Router
AUXiliary connection
MGMT Ethernet port
"Connecting the System Cables" section on page 6-35
To reduce the chance of interference, avoid crossing high-power lines with any interface cables.
Verify all cabling limitations (particularly distance) before powering on the system.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Figure 6-26).
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
4 3 2
3 BITS port
4 Cable-management U feature device
Connecting the System Cables
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
1
to continue the installation.
6-35