Verifying The Basic Interface Parameters; Monitoring The Interface Counters; Displaying Interface Statistics - Cisco 7604-RSP720C-R Configuration Manual

Verifying the Basic Interface Parameters

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Verifying the Basic Interface Parameters
You can verify the basic interface parameters by displaying their values. You can also clear the counters
listed when you display the parameter values.
The system displays only those ports that are allocated to the VDC that you are working in.
Note
DETAILED STEPS
To display basic interface configuration information, perform one of the following tasks:
Command
show cdp
show interface interface
show interface interface
show interface brief
show interface switchport
show interface status err-disabled
show vdc
show udld interface
show udld-global
show port-profile
show system internal pktmgr internal ethernet
slot/port
For detailed information about the fields in the output from these commands, see the Cisco Nexus 7000
Series NX-OS Interfaces Command Reference, Release 5.x.

Monitoring the Interface Counters

You can display and clear interface counters using Cisco NX-OS. This section discusses the following
topics:
•
•

Displaying Interface Statistics

You can set up to three sampling intervals for statistics collections on interfaces.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-54
Displaying Interface Statistics, page 2-54
Clearing Interface Counters, page 2-56
Chapter 2 Configuring Basic Interface Parameters
Purpose
Displays the CDP status.
Displays the configured states of one or all
interfaces.
Displays the configured states of one or all
interfaces.
Displays a table of interface states.
Displays the status of Layer 2 ports.
Displays information about error-disabled
interfaces.
Displays the status of the existing VDCs.
Displays the UDLD status for the current
interface or all interfaces.
Displays the UDLD status for the current device.
Displays information about the port profiles.
Displays the inbound and outbound rate limit
configuration for packets that reach the supervisor
module on a specific interface.
OL-23435-03