Additional References - Cisco 7604-RSP720C-R Configuration Manual

Chapter 7 Configuring vPCs
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
switch(config-if)# switchport trunk allowed vlan 1-50
switch(config-if)# vpc peer-link
switch(config-if)# exit
switch(config)#
Configure the interface for the port channel to the downstream device of the vPC.
Step 9
switch(config)# interface ethernet 7/9
switch(config-if)# switchport mode trunk
switch(config-if)# allowed vlan 1-50
switch(config-if)# native vlan 20
switch(config-if)# channel-group 50 mode active
switch(config-if)# exit
switch(config)# interface port-channel 50
switch(config-if)# vpc 50
switch(config-if)# exit
switch(config)#
Save the configuration.
Step 10
switch(config)# copy running-config startup-config
If you configure the port channel first, ensure that it is a Layer 2 port channel.
Note

Additional References

For additional information related to implementing vPC, see the following sections:
•
•
•
OL-23435-03
Related Documents, page 7-60
Standards, page 7-60
MIBs, page 7-60
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Additional References
7-59