Cisco 7604-RSP720C-R Configuration Manual page 42

Configuring the Basic Interface Parameters
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
3.
4.
5.
6.
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
interface ethernet slot/port
Example:
switch(config)# interface ethernet 3/1
switch(config-if)#
Step 3
{beacon | no beacon}
Example:
switch(config-if)# beacon
switch(config-if)#
Step 4
show interface ethernet slot/port
Example:
switch(config)# show interface ethernet 2/1
Step 5
exit
Example:
switch(config-if)# exit
switch(config)#
Step 6
copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
This example shows how to enable the beacon mode for the Ethernet port 3/1:
switch# configure terminal
switch(config)# interface ethernet 3/1
switch(config-if)# beacon
switch(config-if)#
This example shows how to disable the beacon mode for the Ethernet port 3/1:
switch# configure terminal
switch(config)# interface ethernet 3/1
switch(config-if)# no beacon
switch(config-if)#
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-18
{beacon | no beacon}
show interface ethernet slot/port
exit
copy running-config startup-config
Chapter 2 Configuring Basic Interface Parameters
Purpose
Enters configuration mode.
Specifies an interface to configure, and
enters interface configuration mode.
Enables the beacon mode or disables
the beacon mode. The default mode is
disabled.
Displays the interface status, which
includes the beacon mode state.
Exits the interface mode.
(Optional) Copies the running
configuration to the startup
configuration.
OL-23435-03