Monitoring Vpcs; Configuration Examples For Vpcs - Cisco 7604-RSP720C-R Configuration Manual

Chapter 7 Configuring vPCs
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Command
show vpc peer-keepalive
show vpc role
For detailed information about the fields in the output from these commands, see the Cisco Nexus 7000
Series NX-OS Interfaces Command Reference, Release 5.x.

Monitoring vPCs

Use the show vpc statistics command to display vPC statistics.
This command displays the vPC statistics only for the vPC peer device that you are working on.
Note

Configuration Examples for vPCs

The following example shows how to configure vPC on device A as shown in
Figure 7-11
7/9 port channel 7/7 port channel 7/7 port channel
Enable vPC and LACP.
Step 1
switch# configure terminal
OL-23435-03
vPC Configuration Example
vPC domain 1
Nexus 7000
device A
7/1 port channel 20
vPC
7/2 port channel 20
device
5O 5O 50
port channel
50 port channel
50
Purpose
Displays information on the peer-keepalive
messages.
Displays the peer status, the role of the local
device, the vPC system MAC address and system
priority, and the MAC address and priority for the
local vPC device.
vPC peer
link
Peer-keepalive
link
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Figure
Nexus 7000
device B
vPC
device
Monitoring vPCs
7-11:
7-57