Configuring An Sccp Parameter Map - Cisco 4700M Configuration Manual

Configuring an SCCP Parameter Map

Configuring an SCCP Parameter Map
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
3-112
For example, to specify the appl-parameter http advanced-options command as
an action for the HTTP deep packet inspection policy map, enter:
host1/Admin(config)# policy-map multi-match HTTP_INSPECT_L4POLICY
host1/Admin(config-pmap)# class HTTP_INSPECT_L4CLASS
host1/Admin(config-pmap-c)# appl-parameter http advanced-options
HTTP_PARAM_MAP1
To dissociate the HTTP parameter map as an action from the HTTP deep packet
inspection policy map, enter:
host1/Admin(config-pmap-c)# no appl-parameter http advanced-options
HTTP_PARAM_MAP1
You can use a parameter map to combine related actions for use in a Layer 3 and
Layer 4 Skinny Client Control Protocol (SCCP) application protocol inspection
policy map. You reference this parameter map in the appl-parameter command
in policy map class configuration mode. See the
Map with a Layer 3 and Layer 4 Policy Map"
This section contains the following topics:
• SCCP Inspection Configuration Considerations
Creating an SCCP Parameter Map
•
Enabling Registration Enforcement
•
Setting the Maximum Message ID
•
Setting the Minimum and Maximum SCCP Prefix Length
•
Associating an SCCP Parameter Map with a Layer 3 and Layer 4 Policy Map
•
Chapter 3 Configuring Application Protocol Inspection
"Associating an SCCP Parameter
section.
OL-16202-01