Cisco 4700M Configuration Manual page 360

Configuring Static NAT and Static Port Redirection
Table 5-3
Task and Command Example
7.
8.
9.
10.
11.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
5-34
Static NAT Configuration Quick Start (continued)
Configure a policy map and associate the class map with the policy map.
host1/C1(config)# policy-map multi-match NAT_POLICY
host1/C1(config-pmap)# class NAT_CLASS
host1/C1(config-pmap-c)#
Configure static NAT as a policy-map action.
host1/C1(config-pmap-c)# nat static 192.0.0.0 netmask 255.0.0.0
vlan 101
host1/C1(config-pmap-c)# exit
host1/C1(config-pmap)# exit
host1/C1(config)#
Activate the policy on an interface using a service policy.
host1/C1(config)# interface vlan 100
host1/C1(config-if)# service-policy input NAT_POLICY
host1/C1(config-if)# Ctrl-Z
(Optional) Save your configuration changes to flash memory.
host1/Admin# copy running-config startup-config
Display and verify your static NAT and static port redirection configuration.
host1/C1# show running-config class-map
host1/C1# show running-config policy-map
Chapter 5 Configuring Network Address Translation
OL-16202-01