Cisco 4700M Configuration Manual page 366

Configuring Static NAT and Static Port Redirection
The keywords and arguments are as follows:
•
•
For example, enter:
host1/C1(config)# interface vlan 100
host1/C1(config-if)# mtu 1700
host1/C1(config-if)# ip address 192.168.1.100 255.255.255.0
host1/C1(config-if)# service-policy input NAT_POLICY
To remove a service policy from an interface, enter:
host1/C1(config-if)# no service-policy input NAT_POLICY
When you remove a traffic policy from the last VLAN interface on which you
Note
applied the service policy, the ACE automatically resets the associated
service-policy statistics. The ACE performs this action to provide a new starting
point for the service-policy statistics the next time that you attach a traffic policy
to a specific VLAN interface.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
5-40
input—Specifies that the traffic policy is to be attached to the input direction
of a VLAN interface. The traffic policy evaluates all traffic received by that
interface.
policy_name—Name of a previously defined policy map. The name can have
a maximum of 64 alphanumeric characters.
Chapter 5 Configuring Network Address Translation
OL-16202-01