Closing The Chassis - Cisco 1751V Hardware Installation Manual

Appendix C Installing and Upgrading Memory and Packet Voice Data Modules
Step 5

Closing the Chassis

Step 1
Step 2
Step 3
Step 4
78-11258-04
Push the module towards the slot and press firmly until you hear a clicking sound,
and the module is firmly seated in the slot. Make sure that the snaps on both ends
of the PVDM are engaged. (See
Figure C-4 Installing a PVDM
PVDM module
1
2
After installing memory or data modules on the motherboard, close the chassis by
following these steps:
If you disconnected the fan from the motherboard as described in the
the Chassis" section, reconnect the fan cable to the connector labeled FAN on the
motherboard.
Locate the posts that protrude from the inside of the chassis cover and the
corresponding openings on the chassis bottom.
Line up the posts with the corresponding openings, as shown in
carefully slide the posts into the openings. Be careful not to damage the router
motherboard with the posts.
Replace the screws that you removed when opening the chassis. (See
Figure C-4.)
PVDM snaps
PVDM slot
Cisco 1751 Router Hardware Installation Guide
Closing the Chassis
"Opening
Figure C-5, and
Figure C-1.)
C-9