Closing The Chassis - Cisco 1720 Hardware Installation Manual

2

Closing the Chassis

Cisco 1700 Router Hardware Installation Guide
C-8
Step 5
Figure C-6 Installing a DIMM
DIMM module
1
DIMM slot guides
After installing memory on the motherboard, close the chassis by following these
steps:
Step 1
Step 2
Appendix C Installing and Upgrading Router Memory
Firmly press the DIMM into the slot until the two DIMM
slot guides on each side of the slot move up and over the
end of the DIMM, as in
move up over the edge of the DIMM, move them with
your hands.
2
DIMM slot
If you disconnected the fan from the motherboard as
described in the "Opening the Chassis"
reconnect the fan cable to the connector labeled FAN on
the motherboard.
Locate the posts that protrude from the inside of the
chassis cover and corresponding openings on the chassis
bottom.
Figure C-6. If the guides do not
section,
78-5405-03