Troubleshooting; Disassembling Your Scooter - Abilize ranger Instruction Booklet

Troubleshooting:

1.
• Check AC input. If it works normally, the battery charger may be defective.
2.
• Check if the battery is connected correctly.
• Check if the output connection is short or open.
• If the battery connection is correct, the battery charger may be defective.
3.
• Check if the battery connection is reversed.
• Check if the output connection is short or open.
• Check if the environment temperature is too low (0ºC).
• If the red indicator still keeps flashing, the battery charger may be defective.
4. Charging indicator (orange) can't turn to green:
• The battery may be defective please stop charging and have the battery replaced.
5. If the charging indicator (orange) turns green (fully charged) immediately:
• The battery may be in fully charged condition.
• If the battery is not fully charged, the battery may be defective.
CAUTION:
1. Before using the battery charger, read all instructions and cautionary markings.
2. Use the battery charger in a well-ventilated area.
3. To avoid the risk of injury, charge only lead-acid or gel cell type rechargeable batteries.
4.

Disassembling your Scooter

Seat (P) Disassembling:
Pull the lever (T) upwards to disengage the seat (P), hold the
seat (P) firmly by the backrest and front edge and remove it
upwards from the scooter.
seat to reduce resistance then pull up. Proceed with caution, if you need assistance, please
have someone to help you.
Rear Shroud (Z) and Batteries (C1) Disassembling:
1. Remove rear shroud (Z) upwards.
2. Unplug one battery connector (A1).
3. Release Velcro (B1).
4. Remove two batteries (C1).
14
T
Z
P
A1