Danfoss EKE 1P Operating Manual page 5

Operating Guide | How to update rmware on EKE 1P (080G0325) with counter reset problem
Step 3: Restore backup of
settings using the MMIGRS2
display
Step 4: Start EKE 1P
Step 5: Important
© Danfoss | Climate Solutions | 2024.08
15. To check SW version, connect MMIGRS2 display to the controller and go to controller info screen.
Use the noted data from the backup to program the EKE 1P again using MMIGRS2 display.
The Main switch will have to be set "ON". Please check this!
When the Firmware has been updated it is very important that the EKE 1P module is registered and
marked with new software version 2.15 e.g. "SW2.15". in this way we can all see that the module has
been updated and considered to be OK!
AQ496137645761en-000101 | 5