Table of Contents
Advertisement
FreePort Station User's Manual
2. Preparing the FreePort Station Settings
The AP settings are preformed using a personal computer on the Ethernet LAN. For the proper AP setting, make
sure that the following software are installed in the personal computer (hereafter called the settings personal
computer) on the Ethernet LAN.
TCP/IP protocol ........................ . . Refer to the "TCP/IP Protocol Setting" section below.
FreePort Station Manager ............ Refer to "Installing the FreePort Station Manager".
Web browser (Microsoft Internet Explorer version 4.0 or later, or Netscape Navigator 3.0 or later):
.......................................... . . Refer to the relevant Web browser manual. Microsoft Internet Explorer is
TCP/IP Protocol Setting
The procedure for setting the proper TCP/IP protocol is depending on the OS used in the PC. Please refer to the
following for the proper settings.
Before the setting, check the LAN port drivers are properly installed in the personal computer and it is
connected to the network.
Windows 98/95:
Refer to "On Windows 98/95" below.
Windows 2000:
Refer to "On Windows 2000".
Windows NT 4.0:
Refer to "On Windows NT 4.0".
On Windows 98/95
The TCP/IP protocol is set as follows.
1.
Start your personal computer.
2.
Click the Start button, and then select Settings, and then Control Panel.
3.
Double-click the Network icon.
4.
In the Network dialog box, check that TCP/IP is displayed in the following network components are installed:
Only 1 LAN board installed
If no TCP/IP is displayed. Refer to "Adding TCP/IP Protocos (Windows 98/95)" section.
(on the Personal Computer)
installed as standard on Windows 98 and Windows 2000.
The dial-up adapter and the LAN boards are installed.
TCP/IP (LAN board driver name) is normally displayed in the
following network components are installed:
[TCP/IP-> "LAN board driver name"]
6
Advertisement
Table of Contents
