Ipsec (Internet Protocol Security); Site-To-Site Vpn - TRENDnet TEW-659BRV User Manual

TRENDnet User's Guide

IPsec (Internet Protocol Security)

Site-to-Site VPN

Configuration > Security Setting >VPN-IPsec
To configure an IPsec Site-to-Site VPN tunnel between two VPN routers:
• Ensure that your router is connected to the Internet and computers and
devices are able to access the Internet through your router and make note of
the WAN (Internet) IP assigned to both routers under the Status page. See page
73 for checking the status page.
Example:
VPN Router A WAN (Internet) IP Address:
VPN Router B WAN (Internet) IP Address:
•
Make sure the LAN IP network on each VPN router is different.
Note: Changing the LAN IP address of your router will change the LAN IP
network of your router. See page 53 for changing the LAN IP address.
Example:
VPN Router A LAN IP Settings: 192.168.10.1 / 255.255.255.0
VPN Router B LAN IP Settings: 192.168.100.1 / 255.255.255.0
© Copyright 2012 TRENDnet. All Rights Reserved.
10.10.10.10
10.10.10.20
VPN Router A Configuration
1. Log into your router management page (see "Access your router management page"
on page 50).
2. Click on Configuration at the top of the page, click on Security Setting, and click on
VPN-IPsec.
3. Next to VPN-IPsec, check the Enable option to enable IPsec.
Note: If Enable is not checked, then this will disable all IPsec functionality on your router.
4. For ID 1, check the Enable option and then click Edit.
5. Next to Tunnel Name, enter the tunnel name in the field. (e.g. Tunnel 1)
TEW-659BRV
27