Datamax Mark II M-4206 Operator's Manual page 81

Standard Calibration (continued)
Step Operator Action
9 Observe the display.
10 Exit upon successful
calibration: Back out of the
menu tree by repeatedly
pressing the
If using gap or reflective media,
press and hold the
The printer will begin
advancing media; allow at least
one label gap (or mark) to
advance under the sensor.
Note: A 'Warning Low Backing' message indicates that the calibration was successful with notched media or media on a transparent
liner; see Section 7.1 for details on this and other possible messages.
M-Class
Displayed Message
HBQ!NPEF!
DBMJCSBUJPO!DPNQMFUF!
Or, for reflective media:
SFGMFDUJWF!NPEF!!
DBMJCSBUJPO!DPNQMFUF!
Or, for continuous media:
DPOUJOVPVT!NPEF!!
DBMJCSBUJPO!DPNQMFUF!
!
UIV!22;42B!36NBS3115!!
SFBEZ!
Key.
Key.
!
The calibration was successful.
See note below if another message was displayed.
!
!
!
!
!
!!
The printer is now ready to begin printing.
!
If this calibration was unsuccessful, go to Section
5.4.3.
Comment
71