Datamax Mark II M-4206 Operator's Manual page 106

Displayed Message
!
!
UPQ!PG!GPSN!GBVMU!
!
!
96
Printer Fault Messages
Description
The printer could not find the
TOF mark within the
maximum label length setting
or it found a TOF in an
unexpected place.
Note: When the printer is
set for reflective media, this
fault is given for an out of
stock condition.
(continued)
Possible Solution(s)
If media is moving:
1) Press the FEED Key. It may be necessary to re-calibrate
the printer; see Section 5.4.
2) The Media Sensor may be out of position. Readjust it;
see Section 3.3.
3) The media may not be properly loaded. Reload media,
also ensure that the Media Guide is positioned properly;
see Section 3.2.
4) The Leveling Cam may be improperly adjusted; see
Section 6.2.
5) The label may be longer than the default value for
maximum length. Check the Media Settings / Maximum
Label Length; see Section 5.1.2.
6) The Media Sensor may be obstructed. Check and
carefully remove any obstruction (labels, paper dust,
adhesive, etc).
If media is not moving:
The printhead assembly may not be latched; close it.
M-Class