Printer Setup Mode - Button Functions - Datamax Mark II M-4206 Operator's Manual

4.5 Printer Setup Mode - Button Functions

In 'Printer Setup' mode, the buttons control the setting of the printer's operational items such as media settings,
communications, and options as detailed below.
Notes: It is recommended that the Printer Setup Mode not be entered while in Peel Mode or with the optional Present Sensor
enabled. Depending on label size this can cause unpredictable results.
Printer and cutter faults are disabled during
If at any time you wish to discard your changes and revert back to the previous values, simply turn off power to the printer.
If you wish to restore Factory Defaults see Section 6.7.
To change Printer Setup:
Note: When adjusting CONT FORM LENGTH, LABEL WIDTH, or ALIGN LENGTH, momentarily pressing F1 or F2 will change the
value by one, or hold down the button until the Fault light flashes to change the value by ten for each flash.
M-Class
(Press and hold during power-up until the
PAUSE
Printer Setup Mode
PAUSE Prints the 'Printer Setup Menu List', see section 4.5.1
(
Press and
FEED
Release
(
Press and
FEED
Hold
CANCEL Prints the 'Test Label' for "test"
PAUSE
Saves the current values
+
and resumes
CANCEL
(Current Item and Value is printed)
Printer Setup Procedure
PAUSE
Increments item's value
( Press and
FEED
Release
(
Press and
Hold
CANCEL Decrements item's value
PAUSE
Accepts the current
+
values for "test"
CANCEL
, but can still occur while printing "test" labels.
STOP
)
Feeds one label for "test"
(Enters Printer Setup)
)
Normal Mode
)
Selects the next menu item
)
"Direct Select" menu item
eg. 7 Error light flashes = Baud Rate menu item #7
light turns off)
DONE
21