Haier AS25S2SJ1FA-3 Operation Manual page 9

Opertion
Operation
MODE I FEEL
SLEEP
EXTRA
FUNCTION
ECOSENSOR
TIME TIME CONFIRM
ON
OFF
CANCEL
LOCK LIGHT RESET
IFD filter:
*
In the cooling/heating/fan mode, if you press down the
button of the remote controller, the dust removal filter will slide to
the working position within three minutes and start purifying.
In the smart operation mode, the product will determine whether
the purifying function needs to be turned on or not automatically
according to the PM2.5 concentration value actually detected by
the indoor air quality sensor. If yes, then the purifying function will
turn on automatically. When the PM2.5 concentration drops to a
certain value, the purifying function will turn
you do not need to press the remote
Exit method:
1. While the air conditioner is operating in the purifying mode, if
your press down the PURIFY
will be cancelled and the dust removal filter will slide back its
original position.
Matters needing attention:
1. Users can set whether to turn on the automatic purifying mode
through the APP.
2. When the purifying function is turned on, due to the sliding of
the dust removal filter , slight noise may be generated and this is a
normal phenomenon.
3. If the air quality indicator light still shows red after the purifying
has been operated for a long time period, we recommend you to
replace and clean the dust removal filter.
4. In the purifying mode, low fan speed operation will af fect the
purifying effects.
5. Y ou cannot enter the purifying mode from the self-cleaning
mode directly.
6. The purifying module of this product has transmission
mechanism, so please do not switch on and of f the purifying
function frequently.
Press the PURIFY button on
the remote control.
Purifying Function:
PURIFY
off automatically and
controller.
button, then the purifying function
TURBO
MODE I FEEL
SLEEP
EXTRA
ECOSENSOR FUNCTION
CONFIRM
TIME TIME
ON OFF
CANCEL
LOCK LIGHT RESET
When running in Turbo, the fan speed is the highest.
When running in Quiet, the fan speed is super-slow.
NOTE:
During Turbo operation, in rapid HEAT or COOL mode , the
room will show inhomogeneous temperature distribution. It will
effect desired air temperature that unit is in QUIET operation
for a long period.
6
Operation
Press button. For
each press, fan speed changes as
follows:
Unit will run at selected fan speed.