Advanced Configuration; Retrieving An Ip Address From A Dhcp Server - D-Link xStack DXS-3227 Web/Installation Manual

DXS/DWS 3200 Series User Guide
console# configure
console(config)# snmp-server community priate rw 10.1.1.1 view bobi
console(config)# exit
console# show snmp
Community-String
-------------------- ------------------ -------------- ------------
priate
private
Community-String Group name
------------------ ------------ ------------------- ------
Traps are enabled.
Authentication-failure trap is enabled.
Version 1,2 notifications
Target Address Type
---------------- -------- ----------- ---------- ----- ------- ----- ---
------
Version 3 notifications
Target Address Type
---------------- -------- ----------- -------- ----- ------- ----- -----
----
System Contact:
System Location:
This completes the initial configuration of the device from a local terminal. The configured parameters enable fur-
ther device configuration from any remote location.

Advanced Configuration

This section provides information about dynamic allocation of IP addresses and security management based on
the authentication, authorization, and accounting (AAA) mechanism, and includes the following topics:
•
Configuring IP Addresses through DHCP
•
Configuring IP Addresses through BOOTP
•
Security Management and Password Configuration
When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received from these serv-
ers includes the IP address, and may include subnet mask and default gateway.

Retrieving an IP Address From a DHCP Server

When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. To retrieve an IP
address from a DHCP server, perform the following steps:
1. Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in order to retrieve
the IP address.
2. Enter the following commands to use the selected port for receiving the IP address. In the following example,
the commands are based on the port type used for configuration.
–
Assigning Dynamic IP Addresses:
configure
console#
console(config)#
console(config-if)#
Community-Access View name
read write bobi
read write bobi
IP address
Community Version
Username Security Udp
Level
interface ethernet
1
ip address dhcp hostname
IP address
10.1.1.1
10.1.1.2
Type
Udp Filter To Retries
Port name Sec
Filter To Retries
Port name Sec
<string>
Page 38