Spanning Tree - D-Link DGS-3324SRi User Manual

The Static Router Ports Settings page (shown above) displays all of the current entries to the Switch's static router port
table. To modify an entry, click the Modify button. This will open the Static Router Ports Settings - Edit page, as shown
below.
The following parameters can be set:
Parameter
VID (VLAN ID)
VLAN Name
Unit
Member Ports
Click Apply to implement the new settings, Click the
Static Router Port Entries window.

Spanning Tree

This Switch supports three versions of the Spanning Tree Protocol; 802.1d STP, 802.1w Rapid STP and 802.1s MSTP.
802.1d STP will be familiar to most networking professionals. However, since 802.1w RSTP and 802.1s MSTP has been
recently introduced to D -Link managed Ethernet switches, a brief introduction to the technology is provided below
followed by a description of how to set up 802.1d STP, 802.1w RSTP and 802.1s MSTP.
xStack Stackable Gigabit Layer 3 Switch Manual
Figure 6- 17. Static Router Ports Settings window
Figure 6- 18. Static Router Ports Settings - Edit window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN where the
multicast router is attached.
This is the name of the VLAN where the multicast router is attached.
Choose the Switch ID number of the Switch in the switch stack to be modified.
These are the ports on the Switch that will have a multicast router attached to them.
Show All Static Router Port Entries
69
link to return to the Current