MIMAKI Tiger600-TS Setting Instructions Manual

Tiger600-TS
Print Scan Speed Settings Instructions
Introduction
This document explains how to specify the settings of the print scan speed for the Tiger600-TS.
Read this document carefully before using the printer.
Use this function to reduce the amount of dot offset in the Y direction that occurs between passes as shown in
the figure below.
As this function reduces the scan speed, the productivity of the printer is reduced in exchange for improved
image quality.
Precautions
• It is strictly prohibited to write or copy a part or all of this document without the express permission of Mimaki
Engineering.
• Although every effort has been made to ensure the accuracy of the contents of this document, please contact
your local distributor or our sales office if you have any inquiries or doubts regarding the contents.
• This document is subject to change without notice for reasons of improvement.
• Mimaki Engineering shall not be liable for any damages whatsoever (including, but not limited to, lost profits,
indirect damages, special damages, or other pecuniary damages) arising out of the use of or inability to use this
product, except as provided for by the provisions of the warranty of Mimaki Engineering. The same shall also
apply if Mimaki Engineering has been informed of the possibility of damage. As an example, the company shall
not be liable for any loss of media (such as workpieces or sheets) by the use of this product, or indirect loss
caused by the creation of any materials using the media.
• The latest version of this document can also be downloaded from our website.
Notations Used in this Manual
• Items and buttons that appear in menus and on screens are enclosed in [ ] (brackets), as in [File].
Symbols
• This symbol indicates a precaution item or some action that must be performed.
• This symbol indicates information that is helpful to know.
[Y-direction offset between passes]