Gigabit Ethernet Cx1 (Sfp+ Copper) Connectors; Sfp And Sfp+ Modules - Cisco Catalyst 3560X-24T Hardware Installation Manual

Connector Specifications

10 Gigabit Ethernet CX1 (SFP+ Copper) Connectors

The 10-Gigabit Ethernet electrical modules use CX1 copper connectors similar to the one shown in
Figure
Note
The 10-Gigabit Ethernet optical modules use the connectors shown in
Figure B-2

SFP and SFP+ Modules

Figure
The Catalyst 3560-X switch supports the SFP module patch cable, a 0.5-meter, copper, passive cable
with SFP module connectors at each end
Ethernet SFP ports) to connect two Catalyst 3560-X switches in a cascaded configuration.
Figure B-3
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
B-2
B-2.
When ordering or using CX1 cables, ensure that the version identifier is 2 or higher.
10-Gigabit Ethernet CX1 Copper Connector (example)
B-3, Figure B-4, and Figure B-5
Duplex LC Cable Connector
Appendix B
show the SFP module connectors.
(Figure B-6). This cable can be used (only with 1-Gigabit
Connector and Cable Specifications
Figure B-3 and Figure B-4.
OL-19593-01