Installing A Dc Power Supply - Cisco Catalyst 3560X-24T Hardware Installation Manual

Chapter 3 Power Supply and Fan Module Installation
Do not leave the power-supply slot open for more than 90 seconds while the switch is operating.
Caution
Insert the new power supply into the power-supply slot, and gently push it into the slot
Step 5
When correctly inserted, the 350-W and 715-W power supplies (excluding the power cord retainer) are
flush with the switch rear panel. The 1100-W power-supply module extends 1.5 inches from the switch
rear panel.
Figure 3-6
CO NS OL
S T A C K
Step 6 (Optional) Make a loop in the power cord and thread it through the power cord retainer
Figure 3-7
Step 7 Connect the power cord to the power supply and to an AC power outlet. Turn on the power at the power
source.
Confirm that the power supply AC OK and PS OK LEDs are green. See
Step 8
the power supply module LEDs.

Installing a DC Power Supply

•
•
•
•
OL-19593-01
Inserting the AC-Power Supply in the Switch
E
AU X
RE SE T
1
S T A C K
2
S-P WR
XP S
S-P WR
AC-Power Supply with Power Cord Retainer
W A C
W R -7 15
C 3K X -P
P S O K
A C O K
Equipment That You Need, page 3-8
Grounding the Switch, page 3-9
Installing the DC Power Supply in the Switch, page 3-10
Wiring the DC Input Power Source, page 3-11
AC OK
PS OK
C3 KX -P
WR -71 5W
AC
AC OK
PS OK
C3 KX -P
WR -71 5W
AC
W A C
W R -7 15
C 3K X -P
P S O K
A C O K
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
Installing a DC Power Supply
(Figure 3-6).
(Figure 3-7).
Table 1-18 for a description of
3-7