Uninstalling The Cisco Microsoft Windows Vista And Windows 7 Usb Driver; Entering The Initial Configuration Information; Ip Settings; Configuring The Setup Program - Cisco Catalyst 3560X-24T Hardware Installation Manual

Entering the Initial Configuration Information

Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver

Disconnect the switch console terminal before uninstalling the driver.
Note
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
Step 2 The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4 When the Remove the Program window appears, click Remove.
If a User Account Control warning appears, click Allow - I trust this program to proceed.
Note
When the InstallShield Wizard Completed window appears click Finish.
Step 5
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
is powered on. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet. This information is also needed to use the
device manager or Cisco Network Assistant to configure and manage the switch.

IP Settings

You need this information from your network administrator:
•
•
•
•
•
•

Configuring the Setup Program

If your switches are stacked and there are multiple console connections to individual switches in the
stack, the initial setup dialog appears at the console where you first press Enter.
Completing the setup program and an initial configuration for the switch:
Step 1 Enter Yes at the following two prompts.
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
C-6
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Appendix C Configuring the Switch with the CLI-Based Setup Program
OL-19593-01