Setup > Password - Cisco Linksys RVL200 User Manual

Chapter 4
Keep Alve: Interval
If you select the Keep Alive option,
the Router will send keep-alive packets as often as you
specify. The default Interval is 0 seconds.
Keep Alve: Retry Tmes If you select the Keep Alive
option, the Router will send keep-alive packets as many
times as you specify. If the Router does not receive a
response from the ISP, then the Router will terminate the
connection and start sending PADI packets after the Redial
Period. The default Retry Times is  times.
Keep Alve: Redal Perod
option, the Router will keep the connection alive by
sending out a few data packets periodically, so your ISP
thinks that the connection is still active. This option keeps
your connection active indefinitely, even when it sits idle.
The default Redial Period is 0 seconds.
MTU
The MTU (Maximum Transmission Unit) setting
specifies the largest packet size permitted for network
transmission. To manually set a value, select Manual and
enter the value desired in the field provided. You should
leave this value in the 1200 to 1500 range, and most DSL
users should use the value 1492. The default is Auto,
which allows the Router to select the best MTU for your
Internet connection.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
PPTP (Point-to-Point Tunneling Protocol)
Point to Point Tunneling Protocol (PPTP) is a service that
applies to connections in Europe and Israel only.
PPTP
Specfy WAN IP Address
Enter the external IP address of
the Router.
Subnet Mask
Enter the subnet mask of the Router.
4-Port SSL/IPSec VPN Router
If you select the Keep Alive
Advanced Configuration
Default Gateway Address
default gateway.
DNS Server (Requred) /
Following DNS Server Addresses, enter your DNS server
IP address(es) (enter at least one). Multiple DNS server
IP settings are common. In most cases, the first available
DNS entry is used.
User Name and Password
Name and Password. The maximum number of characters
is 60.
Connect on Demand If you select the Connect on
Demand option, the connection will be disconnected
after a specified period of inactivity (Max Idle Time). If you
have been disconnected due to inactivity, Connect on
Demand enables the Router to automatically re-establish
your connection as soon as you attempt to access the
Internet again. Enter the number of minutes you want to
have elapsed before your Internet access disconnects. The
default Max Idle Time is  minutes.
Keep Alve
If you select the Keep Alive option, the Router
will keep the connection alive by sending out a few data
packets periodically, so your ISP thinks that the connection
is still active. This option keeps your connection active
indefinitely, even when it sits idle. The default Redial
Period is 0 seconds.
MTU
The MTU (Maximum Transmission Unit) setting
specifies the largest packet size permitted for network
transmission. To manually set a value, select Manual and
enter the value desired in the field provided. You should
leave this value in the 1200 to 1500 range, and most DSL
users should use the value 1492. The default is Auto,
which allows the Router to select the best MTU for your
Internet connection.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
Setup > Password
The Router's default User Name and Password is admn,
and Linksys strongly recommends that you change the
Router's password from the default to a unique password.
NOTE:
The password cannot be recovered if
it is lost or forgotten. If the password is lost or
forgotten, you have to reset the Router to its
factory default settings; this will remove all of
your configuration changes.
Enter the IP address of the
If you select Use the
Enter your account's User