Setup > Password; Password; Setup > Time; Time - Cisco RV016 User Manual

Chapter 4
Each of the servers on the DMZ will need a unique, public
Internet IP address. The ISP you use to connect your
network to the Internet should be able to provide these
addresses, as well as information on setting up public
Internet servers. If you plan to use the DMZ setting, contact
your ISP for the static IP information.
The DMZ Setting table displays the DMZ port name in
the Interface column and its IP address in the IP Address
column. Click Edit in the Config. column to change the
DMZ settings of the DMZ port.
Edit DMZ Connection
After you clicked Edit, configure the DMZ settings.
Interface
The DMZ port will be displayed.
Static IP is automatically selected.
DMZ
Specify DMZ IP Address
computer connected to the DMZ port.
Subnet Mask Enter the subnet mask of the computer
connected to the DMZ port.
Click Save Settings to save your changes, or click Cancel
Changes to undo them. Click Back to return to the
Network screen without saving any changes.
Setup > Password
The Router's default User Name and Password is admin,
and Linksys strongly recommends that you change the
Router's password from the default to a unique password.
NOTE: The password cannot be recovered if
it is lost or forgotten. If the password is lost or
forgotten, you have to reset the Router to its
factory default settings; this will remove all of
your configuration changes.
10/100 16-Port VPN Router
Enter the IP address of the
Advanced Configuration
Setup > Password

Password

The User Name is admin; it cannot be changed.
Old Password
Enter the old password. The default is
admin when you first power up the Router.
New Password
Enter a new password for the Router. Your
password must have 20 or fewer characters and cannot
contain any spaces.
Confirm New Password
Re-enter the new password to
confirm it.
Click Save Settings to save your change, or click Cancel
Changes to undo it.
Setup > Time
The Router uses the time settings to time stamp log events,
automatically apply the Access Rules and Content Filter,
and perform other activities for other internal purposes.

Time

To set the local time, select Set the local time using the
Network Time Protocol (NTP) automatically or Set the
local time Manually.
Automatic
Setup > Time > Automatic
Time Zone Select your time zone. The default is (GMT-
08:00) Pacific Time (US & Canada); Tijuana.
14