Table of Contents
Advertisement
Appendx M
Appendx M:
Multple VLANs and
Subnets
Overview
The 4-Port SSL/IPSec VPN Router (model number: RVL200)
can support multiple Virtual Local Area Networks (VLANs)
used with multiple subnets. The configuration example
shows an RVL200 deploying two routers and one Layer 2
managed switch, which deploys three VLANs.
Any router can be deployed; however, this example uses
the Linksys 10/100 4-Port VPN Router (model number:
RV042).
This example also uses the Linksys 48-Port 10/100/1000
+ 4-Port miniGBIC Switch with WebView (model number:
SRW2048); however, any of the Linksys SRW switches with
802.1Q VLAN support can also be used.
RVL200 Configuration
Basic Instructions
1.
To configure the multiple subnets , refer to "Appendix
K: Configuration of Multiple Subnets".
RVL00
RV04 #
192.168.7.x
Default VLAN1
192.168.20.x
4-Port SSL/IPSec VPN Router
2.
To configure the multiple VLANs, refer to "Appendix L:
Multiple VLANs with Computers".
3.
Access the web-based utility of the RVL200. (Refer to
"Chapter 4: Advanced Configuration" for details.)
4.
Click the DHCP tab.
5.
Click the Multple VLANs tab.
Select Enable Multple VLANs.
6.
7.
VLAN1 is configured by default. For VLAN2, complete
the following:
–
Port 4: Trunking Port
VLAN2
192.168.1.x
RV04 #
192.168.2.x
RVL200 with Multiple VLANs and Subnets
Multiple VLANs and Subnets
DHCP > Multiple VLANs
IP Address
Enter 9.8... (This is the default,
which you can overwrite.)
VLAN3
192.168.3.x
SRW048
VLAN4
192.168.4.x
9
Advertisement
Table of Contents
Troubleshooting
