Appendix K: Configuration Of Multiple Subnets; Overview; Rvl200-To-Rv042 Configuration; Rvl200 Configuration - Cisco Linksys RVL200 User Manual

Appendx K
Appendx K:
Confguraton of Multple
Subnets

Overview

The 4-Port SSL/IPSec VPN Router (model number: RVL200)
can support multiple subnets. The configuration example
shows an RVL200 deploying two routers.
Any router can be deployed; however, this example uses
the Linksys 10/100 4-Port VPN Router (model number:
RV042).
RVL00
LAN IP: 192.168.1.1
Multiple Subnet
IP: 192.168.7.0/24
Multiple Subnet
IP: 192.168.20.0/24
192.168.7.x
Default VLAN1
4-Port SSL/IPSec VPN Router
RV04 #
WAN IP: 192.168.1.2
LAN IP: 192.168.7.254
Working Mode: Router
Firewall: Disabled
Statc Route
Destination IP: 192.168.20.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.20
Interface: WAN1
192.168.20.x
RVL200 with Multiple Subnets
Configuration of Multiple Subnets

RVL200-to-RV042 Configuration

To create this configuration, you create two subnets and
two static routes on the RVL200. Then on each RV042, you
set it to Router mode, disable the firewall, and set up a
static route.

RVL200 Configuration

1. Physically connect a numbered port (Ethernet 1-4) on
the RVL200 to the WAN 1 port of the RV042.
2. Access the web-based utility of the RVL200. (Refer to
"Chapter 4: Advanced Configuration" for details.)
3. Click the Setup tab.
Statc Route #
Destination IP: 192.168.7.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.2
Interface: LAN
Statc Route #
Destination IP: 192.168.20.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.20
Interface: LAN
RV04 #
WAN IP: 192.168.1.20
LAN IP: 192.168.20.254
Working Mode: Router
Firewall: Disabled
Statc Route
Destination IP: 192.168.7.0
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.2
Interface: WAN1
192.168.1.x
9