Ipsec Vpn > Vpn Pass Through; Vpn Pass Through; Ssl Vpn > Summary; Summary - Cisco Linksys RVL200 User Manual

Chapter 4
the Router will disconnect the tunnel so the connection
can be re-established. Specify the interval between
HELLO/ACK messages (how often you want the messages
to be sent). DPD is enabled by default, and the default
interval is 0 seconds.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
IPSec VPN > VPN Pass Through
The VPN Pass Through screen allows you to enable or
disable passthrough for a variety of VPN methods.
IPSec VPN > VPN Pass Through

VPN Pass Through

IPSec Pass Through
Internet Protocol Security (IPSec) is
a suite of protocols used to implement secure exchange
of packets at the IP layer. IPSec Pass Through is enabled by
default to allow IPSec tunnels to pass through the Router.
PPTP Pass Through
Point-to-Point Tunneling Protocol
(PPTP) allows the Point-to-Point Protocol (PPP) to be
tunneled through an IP network. PPTP Pass Through is
enabled by default.
LTP Pass Through Layer 2 Tunneling Protocol is the
method used to enable Point-to-Point sessions via the
Internet on the Layer 2 level. L2TP Pass Through is enabled
by default.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
SSL VPN > Summary
This screen displays general information about the SSL
VPN tunnels. The Router supports up to five SSL VPN
tunnels.
4-Port SSL/IPSec VPN Router
Advanced Configuration
SSL VPN > Summary

Summary

Tunnel Used
The number of VPN tunnels being used is
displayed.
Tunnel Avalable The number of available VPN tunnels
is displayed.
Active Users
This section displays the active users using Virtual Passage
and administrative users logged into the SSL VPN Portal.
User Name
This is the name of the user.
IP Address
This is the IP address of the user.
Logn Tme
This is the time stamp indicating when the
user logged in.
Status
Displayed here is the user's status, "Login" or
"Connected. " The status line will also display "Login" for
administrative users who logged in through the Portal
and did not create an SSL tunnel by Virtual Passage.
Logout Any administrative user can click the Trash Can
icon to terminate a user session and log the user out.
SSL VPN > Certificate Management
Manage the certificate used for securing communications
between the Router and VPN clients.
SSL VPN > Certificate Management
40