Table of Contents
Advertisement
Appendx I
7.
The WAN IP address (B.B.B.B) of the RV082 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RV082's local network settings in the IP Address and
Subnet Mask fields.
RV082 VPN Settings
For the Remote Security Gateway Type, select IP
8.
address. Enter the RVL200's WAN IP address in the IP
Address field.
9.
For the Remote Security Group Type, select Subnet.
Enter the RVL200's local network settings in the IP
Address and Subnet Mask fields.
10.
In the IPSec Setup section, select the appropriate
encryption, authentication, and other key management
settings. (These should match the settings of the
RVL200.)
11.
In the Preshared Key field, enter a string for this key, for
example, 13572468.
RV082 IPSec Setup Settings
If you need more detailed settings, click Advanced
12.
Settngs. Otherwise, click Save Settngs.
Configuration of PC 1 and PC 2
Verify that PC 1 and PC 2 can ping each other (refer to
Windows Help for more information). If the computers
can ping each other, then you know the VPN tunnel is
configured correctly.
4-Port SSL/IPSec VPN Router
Gateway-to-Gateway VPN Tunnel
Configuration when Both Gateways Use
Dynamic IP Addresses
This example assumes both Gateways are using dynamic IP
addresses. If the Remote Gateway uses a static IP address,
refer to "Configuration when the Remote Gateway Uses
a Static IP Address. " If only the Remote Gateway uses a
dynamic IP address, refer to "Configuration when the
Remote Gateway Uses a Dynamic IP Address. "
RV082
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using
Dynamic IP
NOTE:
Each computer must have a network
adapter installed.
Configuration of the RVL200
Follow these instructions for the first VPN Router,
designated RVL200. The other VPN Router is designated
the RV082.
1.
Launch the web browser for a networked computer,
designated PC 1.
2.
Access the web-based utility of the RVL200. (Refer to
"Chapter 4: Advanced Configuration" for details.)
Click the IPSec VPN tab.
3.
Click the Gateway to Gateway tab.
4.
5.
Enter a name in the Tunnel Name field.
For the VPN Tunnel setting, select Enable.
6.
7.
The WAN IP address (A.A.A.A) of the RVL200 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RVL200's local network settings in the IP Address
and Subnet Mask fields.
RVL200
Dynamic IP: A.A.A.A with
Domain Name: www.xyz.com
LAN: 192.168.5.1
8
Advertisement
Table of Contents
Troubleshooting
